Hope you have a good day. Could you please tell me how to deal with this, After installation of Application Builder 4.0 in "laptop" ander windows XP
when i try to connect whith this laptop to AC160 I get alarm
Add new comment
Thank you so much for your response, my engineering station connect to ac160 via com port, Recently my hard disk drive died, i change new one and reinstall APB, but i don’t know if i install new win 2k and install APB it will connectable to the AC160 via comport yet? Or Need I do anything else ?
It uses windows 2k before and I just check again that the Application Builder is 4.1 version. Hope to hearing from you...
According AC160 user's manual, COM-A port at CPU used for engineering station is fixed to the following parameters: speed 9600 bit/sec, No parity, 1 stop bit, 1 start bit.
So set your COM ports settings accordingly in Win 2K. Select proper COM port number in FCB for connection to the target.
I repeat as far as I remember APB 4 cannot connect by serial to AC110 in Win XP , assuming the same situation is for AC160. Maybe I am wrong then someone please correct me.
Thank you so much and hope you have a good night