UNRECOGNIZED ERROR CODE -9!
I received the " UNRECODNIZED ERROR CODE -9!" upon trying the command " #C PC1.3.8" on the online Chart Builder. What could be the problem and how can it be resolved
Asked 10 months ago
Answers
This question has not yet been answered.
by Martin87 Rank: 93 on 8/13/2020 12:39:25 PM | Like (0) | Report
Do you mean Online Builder?
by ggarcia Rank: 13675 on 5/6/2021 3:24:19 PM | Like (0) | Report
Sorry for taking and old post, but seems to be the only post about this error and PU410.
I have the same error trying to access to a specific node when trying to Online Builder . There are 6 nodes, and just one node is getting this error.
We have two PU410, one of them can access to any node, the other board can access any node but one.
I get this error by making a C PCx.x.x.x, GEPCD... Seems a bad communication between node and that PU410.
Tried to power off and boot again the PU410 with no effect.
What could be wrong?
Thank you
by ggarcia Rank: 13675 on 5/6/2021 3:49:06 PM | Like (0) | Report
P.S.: It is a MB300 network, without 800xA.
Add new comment