ABB Compact Control BuilderAC 800M 5.0.2_3 unable to start
Hi,
I finally managed to install compact control builder to computer (Windows 10 operation system)
However, it doesnt start. There is no errors appearing. Just nothing happens when i try to run program. Installation went to end with no errors and everything looks fine.
Can you help with this
I finally managed to install compact control builder to computer (Windows 10 operation system)
However, it doesnt start. There is no errors appearing. Just nothing happens when i try to run program. Installation went to end with no errors and everything looks fine.
Can you help with this
Answers
Try to run in windows compatibity mode , right click on the exce file and select compatibility mode
1.0 -
2.0 was built for Windows 2000
3.0 -
- 5.0 was built for Windows XP
5.1 was built for Windows 7
6.0 was built for Windows 8
6.0.3.2+ support Windows 10
Combinations outside the "3BUAxxxxxx Third Party Software versions" documents are likely to fail and will not receive any product support.
Use of a HyperVisor, eg VMware is recommended for corner cases. You will likely succeed with a virtual XP computer.
2.0 was built for Windows 2000
3.0 -
- 5.0 was built for Windows XP
5.1 was built for Windows 7
6.0 was built for Windows 8
6.0.3.2+ support Windows 10
Combinations outside the "3BUAxxxxxx Third Party Software versions" documents are likely to fail and will not receive any product support.
Use of a HyperVisor, eg VMware is recommended for corner cases. You will likely succeed with a virtual XP computer.
by Matti Langvall Rank: 145 on 8/7/2020 12:57:59 AM | Like (0) | Report
Is MMS Service starting ?
Add new comment