AC500 Redundant PLC System & Profibus ring network using OLM
Hi,
I was thinking of creating Redundant PLC System as per attached architecture.
I've created ring network of profibus using OLM.
Am I doing correct?
Modules used
CPU - PM591-ETH
ETHERNET COMMUNICATION - CM597-ETH
DP MASTER - CM592-DP
COMM MODULE FOR I/O - CI522-MODTCP
Thanks in advance!
I was thinking of creating Redundant PLC System as per attached architecture.
I've created ring network of profibus using OLM.
Am I doing correct?
Modules used
CPU - PM591-ETH
ETHERNET COMMUNICATION - CM597-ETH
DP MASTER - CM592-DP
COMM MODULE FOR I/O - CI522-MODTCP
Thanks in advance!
Asked 10 months ago
Answers
0
I did the TCP-IP redundancy as per shown in architecture but i think profibus redundancy is not supported by our ac500 series.....but you also confirm bby abb team...
Answered 10 months ago
Add new comment