ACS355 Drive won't save parameters
I have three ACS355-01E-02A4-2 drives. I would like to load a new parameter set into each drive.
I am using Drivewindow light 2 to download the new parameter set to the drive.
I can load the new parameter set into the drive and the drive will run with the new parameter set, however when the power is cycled off and on the drive reverts back to the old parameter set.
I have tried using parameter 1607 to save the parameters but it does not work. Also tried changing a parameter using the keypad and same problem.
I am using Drivewindow light 2 to download the new parameter set to the drive.
I can load the new parameter set into the drive and the drive will run with the new parameter set, however when the power is cycled off and on the drive reverts back to the old parameter set.
I have tried using parameter 1607 to save the parameters but it does not work. Also tried changing a parameter using the keypad and same problem.
Answers
Hi Simon
the behavior you write is very strange, above all because you say you have already saved data with parameter 16.07.
Can you tell me what is the FW version of your drives?
Have you tried from the Drive Window Lite menu to make a backup after making the changes and then a restore? You can find these commands in the drive menu -> parameter and signals -> backup / restore
Let us know about the result
BR
Flavio
the behavior you write is very strange, above all because you say you have already saved data with parameter 16.07.
Can you tell me what is the FW version of your drives?
Have you tried from the Drive Window Lite menu to make a backup after making the changes and then a restore? You can find these commands in the drive menu -> parameter and signals -> backup / restore
Let us know about the result
BR
Flavio
Add new comment