Device Managment Basic HART DTM
Hello all,
I need to connect to a ABB LT300 Ultrasonic Level instrument using 800xA 6.1 with AI815 modules using HART protocol.
I didn't found the DTM prepared to install using DLW (Device Library Wizard) so I would like to use a generic hart DTM.
I have a this zip file "2PAA120824D0207_A_en_ABB Basic HART DTM - HART DTM Builder 6.1.0-0" but inside have a pdf and a exe file.
Where I have to install this file? on Primary Aspect Server?.
Regards
I need to connect to a ABB LT300 Ultrasonic Level instrument using 800xA 6.1 with AI815 modules using HART protocol.
I didn't found the DTM prepared to install using DLW (Device Library Wizard) so I would like to use a generic hart DTM.
I have a this zip file "2PAA120824D0207_A_en_ABB Basic HART DTM - HART DTM Builder 6.1.0-0" but inside have a pdf and a exe file.
Where I have to install this file? on Primary Aspect Server?.
Regards
Asked 5 months ago
Answers
0
Do not install any 800xA software manually unless specifically asked for. All installation is handled by System Configuration Console in 800xA version 6.x. For Basic HART DTM functionality select following option in SCC. It will take care of installation in all the nodes.
![]()
Answered 5 months ago
Add new comment