Attempting to start phase while PHASE_INACTIVE error message
We had a controller go down with three MOD phases executing at the time. After rebooting controller, none of these phases will execute. Whenever the Batch PFC tries to execute one of them, we get the following error message..."Attempting to start phase while PHASE_INACTIVE". We have found nothing in our 800xA help documentation regarding this error.
We tried adding another instance of the phase to currently running PFC...same error message. We tried removing the phase from the Unit and creating a new phase with the same name...same error message. We tried disabling the unit from the Batch unit list and then enabling it...same error message.
The only thing we found that works is creating a totally new phase with a different phase name, pointing the new phase to the same TCL sequence as the old phase and putting an instance of the new phase in the PFC.
It appears that we can no longer use a phase with the old phase name.
Anyone else had this problem and found a better solution...?