ethernet communication
Hello All,
Greetings of the day
I have connected an ethernet cable to my plc PM554 TP ETH to my pc. I scanned for the IP configuration and it scanned and got the IP address and I selected it in communication settings but I can't log in to my plc. It shows check is plc is connected! what would be the problem in communication between my plc and pc
Greetings of the day
I have connected an ethernet cable to my plc PM554 TP ETH to my pc. I scanned for the IP configuration and it scanned and got the IP address and I selected it in communication settings but I can't log in to my plc. It shows check is plc is connected! what would be the problem in communication between my plc and pc
Voted best answer
Hi
verify that your PC and your PLC are in the meantime on the same domain, after which you must set the communication parameters in the Automation Builder.
Some possible more ideas can be found in the tutorials like the following (link):
https://www.youtube.com/watch?v=sIUFx...
BR
Flavio
verify that your PC and your PLC are in the meantime on the same domain, after which you must set the communication parameters in the Automation Builder.
Some possible more ideas can be found in the tutorials like the following (link):
https://www.youtube.com/watch?v=sIUFx...
BR
Flavio
by Amal Rank: 84 on 2/21/2020 10:07:37 PM | Like (0) | Report
Should I do anything more than that for an ethernet communication
Add new comment