UMC100 SW version different/ wrong module type
I’ve got an UMC100.3 connected through PNQ22 – CI871 – Profinet to a PM866 controller.
When downloading parameters to the UMC from Control Builder, I get the message “wrong module type, module missing”.
If I try to download parameters from the LCD panel on the UMC, I get the message “UMC100 SW version different”
The parameters are not transferred to the UMC, and the drive cannot be operated from the controller.
Software version is 3.05.0
(I have another UMC100.3 with SW:3.04.7 connected to the same PNQ22, working just fine…)
Can the software be changed?
Any detail on the issue would be very much appreciated
Thank you in advance!
This question has not yet been answered.