Freelance Asset Management IAMS
AFTer installing DTM files in engineering station and make the configuration inside the freelance engineering, in the operator station which we need to use freelance operation to make hart configuration. in diag mode it is written DTM not available , how can i fix this ?
Answers
I do not fully understand your question, and i have no idea how to fix such an error.
But i have years of painful experiences with FDT/DTM on Freelance, Pactware and Fieldcare. The whole FDT/DTM technology is a big mess. Proper working combinations of Containers (Freelance CBF) and DTM (Remote IO?) are the minority. I often experienced crashed CBF while using DTM's, i even seen the CBF project destroyed twice! (lucky we had backup) Since we replaced all DTM's with GSD, Freelance CBF runs rock solid.
So if you can avoid using DTM, please avoid.
(Sorry if this not help you, but if I read about "DTM", i cannot hold back...)
But i have years of painful experiences with FDT/DTM on Freelance, Pactware and Fieldcare. The whole FDT/DTM technology is a big mess. Proper working combinations of Containers (Freelance CBF) and DTM (Remote IO?) are the minority. I often experienced crashed CBF while using DTM's, i even seen the CBF project destroyed twice! (lucky we had backup) Since we replaced all DTM's with GSD, Freelance CBF runs rock solid.
So if you can avoid using DTM, please avoid.
(Sorry if this not help you, but if I read about "DTM", i cannot hold back...)
You need to install the DTMs also on the PC running Freelance Operations.
Add new comment