MicroScada command error ''Scil 13222''
Hello Everyone,
I would like to get help from you about error while sending command to equipments (CB,DC) at MicroScada.When I sent open or close command to equipment I got ''scil error 13222'' as you see below on the picture.Could you please help me to solve this problem?Because it is really urgent.
Thank you
I would like to get help from you about error while sending command to equipments (CB,DC) at MicroScada.When I sent open or close command to equipment I got ''scil error 13222'' as you see below on the picture.Could you please help me to solve this problem?Because it is really urgent.
Thank you
Asked 10 months ago
Answers
0
Make sure that local/remote switch is on remote position.
What is this IED?
What is this IED?
Answered 10 months ago
Add new comment