ACS580 - Speed Reference not mapping
I am connected to the ACS 580 by profinet, sending a 12000 signal as my speed ref. When I start the drive remotely, I can see the correct value of 30.0hz in 03.05, however no speed is being given to the actual motor speed. My parameters configured are: 22.11 FB A ref 1 22.13 Ref1 Are there any parameters that I am missing here? The drive runs fine in local mode
Answer this question Follow
Voted best answer
ok, normally for use with ProfiNet you must also set the IP node of the drive correctly, and then the following parameters: 20:01 for the start via fieldbus 22:11 28.11 And of course the parameter group 50, 51 52, 53 with the appropriate commands Do not forget to refresh the fielbus attributes, after any modification, with parameter 51.27 Hope this help you BR Flavio
what type of master Profinet are you using? What value are you write in CW to start the drive? BR Flavio
Other questions needing answers
Application Knowledge Store (AKS) will no longer be available after the 31 July 2021.
We are enhancing our Customer and Partner experience and will be migrating data from AKS to the new portal.
During the transition please direct your questions to:
If you are an ABB customer with a CARE Agreement you can access our Customer Portal, where you can find solutions and ask questions, and communicate directly with ABB.
If you are not an existing CARE customer with ABB please contact your local ABB sales office.
For our authorised Partners you can directly access additional support information in the Partner Portal