IEC61850 scd upload failed in 800xA version 6.1
We have a new project, where we are using 800xA version 6.1.
V6.1 introduces a new "engineering " with regards to the IEC61850 configuration.
We are trying with the decoupled engineering, and have therefore only used IET600 for assigning our server to the relays .
This means that we do not have any substation, voltage level, bay and conduction equipment in the SCD file imported into 800xA, but only the subnetwork with six relays and one OPC server.
When importing the file from IET600 in 800xA, we use the new way of uploading. Though, when doing this, we get an error message stating that the operation failed, as seen in the attached picture UploadError.
Attached is also the scd file imported in the system.
Have anybody tried the new engineering workflow for the IEC61850 configuration, and from this know what the cause of our problem can be?
Investigations done and their results:
We have tried using the old CET software, on another development system, and that does not give any errors.
We have also tried using an scd file from an old project, which was working in the old system, but get the same error.
There does not appear to be any further information, and it writes nothing to the log file, located at C:\OperateITData\Temp\Uploader\.
We have tried deleting and recreating the structures multiple times, following the manual, to see if any error was done during setup, but still receive the same error.
In advance, thanks a lot for your answers.
This question has not yet been answered.