ACS355 AC driver fault F0009
I have a ABB ACS355-01E-04A7-2 driver and Im trying to connect it to a old 3phase motor.
This is te name plate of the motor,
My Basic parameters as below,
Motor Type(9903) = 1(Asynchronous motor)
Application macro(9902) = 1(ABB Standard)
Motor control mode(9904) = 3(Scalar:Frequency)
Nominal Voltage(9905) = 230V
Nominal Current(9906) = 3.5A
Nominal frequency(9907) = 50Hz
Nominal speed(9908) = 3000RPM
Nominal Power(9909) = 2.4
Motor rotate about 5min and automatically stopped by alarm(F0009 - Overheat).
There is no unit in parameter 9909(Nominal power). I have set it 0.5 at first time and same thing happened. Then I increase it to maximum value(2.4). But it also stopped the motor.
Motor get hot slightly.
I also have question about parameter setting,
I have a basic control panel.
As below, How should I set motor current and power? Is my above parameters are correct?
If not please describe what are the highlighted things on user manual.
This is the user manual: http://search.abb.com/Library/Downloa...
Thanks in advance