Profibus - Station diagnosis
hi
I am using PM583-Eth and CM572-dp to communicate ACS550 drive.
In profibus master -> diagnostics for profibus -> station diagnosis -> station state of 2 is in yellow indication (diagnosis state).
but communication are working i can able to read and write the data from plc to drive and drive to plc.
kindly guide me how to make station state in Active state?
I am using PM583-Eth and CM572-dp to communicate ACS550 drive.
In profibus master -> diagnostics for profibus -> station diagnosis -> station state of 2 is in yellow indication (diagnosis state).
but communication are working i can able to read and write the data from plc to drive and drive to plc.
kindly guide me how to make station state in Active state?
Answers
Hi
probably you have activate the diagnosis state with the specify flag on Automation Builder.
If I remember correctly, a new access to the program should restore the active status.
Alternatively you can try to reboot the PLC + DRIVE, if the conditions of your system allow it.
However, I see it as a marginal problem, since communication between the devices is guaranteed anyway.
BR
Flavio
probably you have activate the diagnosis state with the specify flag on Automation Builder.
If I remember correctly, a new access to the program should restore the active status.
Alternatively you can try to reboot the PLC + DRIVE, if the conditions of your system allow it.
However, I see it as a marginal problem, since communication between the devices is guaranteed anyway.
BR
Flavio
Add new comment