Data lost in Multisystem connection
Now I have two redundant systems: regional SCADA (AS&CS, workgroup) as remote access server, Master system (AS+CS, domain) as remote access client, multisystem connection was established successfully before, all live data could be shown in Master system. Recently I found some particular data will be lost in Master system when MI connection to one regional SCADA server, so I disabled/enabled the connection again, those data will be recover and still be lost again in few minutes. Only when you open the related faceplate or graphics of the object, the data could keep alive, once you close the faceplate or graphics, the data lost. Open the control connection of those objects and subscribe it, the information 'not connected' shown there. Everything is fine when Master system connect to another regional SCADA server.
System version: 6.0.3
Can anyone tell me where is the problem and how to fix it?
System version: 6.0.3
Can anyone tell me where is the problem and how to fix it?
Answers
Nothing obvious comes to my mind - I therefore recommend filing a support case with your regional ABB support center. Once we have a case we can start working on it...
I also searching the same information. I lost my data from my hard drive and searching the data recovery service center. Because data recovery software can be recover all data from dead hard drive.
Data recovery is not difficult and it is very simple to do. You should have no problem recovering your data if you have access to the original file. You will want to take a few minutes and review the tips and tricks that are provided in this article before trying to recover your lost data.
Data Recovery Dubai helps yo to recover safe data
Data Recovery Dubai helps yo to recover safe data
Add new comment