Add new comment
Only error F0101 is there and "Fault" message appears on the left, i had checked user manual faund Code Description
0101 SPEED & DIR
The calculated signed speed of the motor (rpm). The absolute value of 0101 SPEED & DIR is the same as the value of
• The value of 0101 SPEED & DIR is positive if the motor runs in the forward direction.
• The value of 0101 SPEED & DIR is negative if the motor runs in the reverse direction.
Your drive is controlled by a field bus or via HW?
you can try to run the motor in LOCAL mode, by pressing the LOC/REM on control panel, then set the speed/rpm by control panel.
If the drive does not respond, maybe you need to change with one new