Red triangles and 16#00000030 Channel error on CPU modul bus can't be closed
Hi, have a project with 2 DO and 1 DI810 units connected.
When connecting a relay component all ports turned into 16#00000030 Channel error mode and displaying a red triangle on each port.
Any clues to solving /closing the issues?
See attached image
Answers
Hi, I have found the answer, finally.
The sockets have power supply and one of the cables (main supply cable) was disconnected ;(
Would hope that ABB could implement a check and error message that fault for guys like me with less experiance.
Write the answer here to help others
The sockets have power supply and one of the cables (main supply cable) was disconnected ;(
Would hope that ABB could implement a check and error message that fault for guys like me with less experiance.
Write the answer here to help others
Add new comment