Faceplate pinned by default
Hi,
in all former 800xA system a faceplate was pinned by default. In the new 6.0.3 it is not. I've set the "workaround" with "preserve" instead of "replace". This open more than one faceplate but at the same position. With the pinned faceplate, a new faceplate will be open a litte bit left and down of the position.
Does anyone know how to change the default behavior? There is a "Pinned" Rule in the Faceplate System View Class but it seems not to have an effect.
/Erik
in all former 800xA system a faceplate was pinned by default. In the new 6.0.3 it is not. I've set the "workaround" with "preserve" instead of "replace". This open more than one faceplate but at the same position. With the pinned faceplate, a new faceplate will be open a litte bit left and down of the position.
Does anyone know how to change the default behavior? There is a "Pinned" Rule in the Faceplate System View Class but it seems not to have an effect.
/Erik
Answers
Hi!
This is described in the engineering manual for PG2 (3BSE049230-600_B_en_System_800xA_Engineering_6.0_Process_Graphics, page 367-368).
Remember to restart your workplace and also run it in "operator workplace" mode.
Also check if your application uses the "standard" System View Class.
Good Luck!
This is described in the engineering manual for PG2 (3BSE049230-600_B_en_System_800xA_Engineering_6.0_Process_Graphics, page 367-368).
Remember to restart your workplace and also run it in "operator workplace" mode.
Also check if your application uses the "standard" System View Class.
Good Luck!
Add new comment