I'm about to upgrading a my system 5.1 revE FP4 to 6.1. and i have a couple of questions,
1. In my 5.1 system the the abb products installed, does all of them exist in 6.1 (attached picture)? 2. Is there an easy way to find these products when using the SSC? when i try to install some product 10 more products install that i don't want to have, and there is no going back after deploy... can i install it product by product manually by browsing on the installation disk or will i have problem next time i need to upgrade my system?
All of these ABB software are available in 800xA V6.1.
From 800xA V6.0, only System Configuration Console is recommended to be used for software installation. It will take care of required software to be installed based on your selection of Node Functions. If manual installation is performed, unexpected problems are expected during software upgrade.
during the upgrade for all your objects old aspects will be replaced by new ones. If you still use old VB stuff this will not be supported anymore. So please check, especially for Advant Master, that you replace all VG graphic with PG2 graphic.