AC500 eco PM554ETH E3 I/O-Bus invalid confiugration
when i try to download simple LD program to PM554-ETH using automation builder V2.2 or control builder plus
the error led goes on and i at the bottome left of the screen in codesys i see E3 I/O-bus invalid configuration
there are only 1digital input and 1digital output in the program
is it an ip problem ? or how i could solve this problem
the error led goes on and i at the bottome left of the screen in codesys i see E3 I/O-bus invalid configuration
there are only 1digital input and 1digital output in the program
is it an ip problem ? or how i could solve this problem
Asked 11 months ago
Answers
0
Hi
have you correctly configured the HW in your project?
Maybe Automation Builder found a mistake by your project and the real HW.
Try to post a screen shot of your monitor with the error
BR
Flavio
have you correctly configured the HW in your project?
Maybe Automation Builder found a mistake by your project and the real HW.
Try to post a screen shot of your monitor with the error
BR
Flavio
Add new comment