AC900F Ip seeting by Daig. cable
I have set ip address of controller PM902F though daig. cable. it has been set successfully . but i m unable to ping controller though Engineering PC
also i have i want to mention i don't have internal battery also it not updated firmware because controiller ip is not pinging
also i have i want to mention i don't have internal battery also it not updated firmware because controiller ip is not pinging
Asked 11 months ago
Answers
0
Hello,
looking at your picture it seems to me you have altered the IP address of ETH 2, which is used for redundancy purposes. The main Ethernet port ETH 1 is still on 172.16.1.1
If you connect to the controller through ETH 1 you should still be able to ping the controller under that IP. I propose to first update the controller, before changing the main IP address ETH 1
looking at your picture it seems to me you have altered the IP address of ETH 2, which is used for redundancy purposes. The main Ethernet port ETH 1 is still on 172.16.1.1
If you connect to the controller through ETH 1 you should still be able to ping the controller under that IP. I propose to first update the controller, before changing the main IP address ETH 1
Add new comment