How to configure redundant PM-583 PLC in automation builder
Hello,
I am new to the automation builder and ABB PLC. Currently I am doing a project based on PM-583 ETH CPUs.
I need to configure two PM-583 CPUs for redundancy. My system includes two CI-590 CS31 modules. (refer the attached System archutecture).
Can anyone provide the guidelines for hardware configuration settings?
I m not able to see Ac-500 parameters in Codesys PLC configuration.
I am new to the automation builder and ABB PLC. Currently I am doing a project based on PM-583 ETH CPUs.
I need to configure two PM-583 CPUs for redundancy. My system includes two CI-590 CS31 modules. (refer the attached System archutecture).
Can anyone provide the guidelines for hardware configuration settings?
I m not able to see Ac-500 parameters in Codesys PLC configuration.
Voted best answer
Hi
try with the attached document.
Hope this help you
BR
Flavio
try with the attached document.
Hope this help you
BR
Flavio
Add new comment