AC800M OPC Connectivity server is not able to autoload the opc configuration after restart
AC800M OPC Connectivity server is not able to autoload the opc configuration after restart even after the file is configured for autostartup.
any one faced similar issue , how to solve the same ?
any one faced similar issue , how to solve the same ?
Answers
Is this question posted from the same site? https://forum-controlsystems.abb.com/...
Did you try delayed start as I hinted in a comment there?
Is this 6.1? 6.0.3.2? 5.1?
Are you using Windows 10 2015 or 2016 LTSB or the not supported Windows 10 Pro?
I believe you should put more trust into the official and professional support service delivered by your regional ABB team.
AKS is not an official support forum. As with many other publically available and lightly moderated Internet forums, proper filtering is required as many different ideas are posted and some are straightforward *wrong* and may put you in an even less favorable situation than before.
Did you try delayed start as I hinted in a comment there?
Is this 6.1? 6.0.3.2? 5.1?
Are you using Windows 10 2015 or 2016 LTSB or the not supported Windows 10 Pro?
I believe you should put more trust into the official and professional support service delivered by your regional ABB team.
AKS is not an official support forum. As with many other publically available and lightly moderated Internet forums, proper filtering is required as many different ideas are posted and some are straightforward *wrong* and may put you in an even less favorable situation than before.
Add new comment