E_AFW_SI_SEC_NOT_INITED(0x8abb1003) security not initialized
Hi,
Fresh installation of ESWS client installed successfully, But node connection is not happening for ESWS client. Please find the log file attached for your reference.
While trying connect client from ASDS1 server it pop ups an message "E_AFW_SI_SEC_NOT_INITED(0x8abb1003) security not initialized". Pleases refer screen shot below.
If any file need for investigation pls let me know.
Regards,
Voted best answer
1. Check firewall rules configured in this node.
2. Run 'System software User settings' again on this node from configuration wizard.
2. Run 'System software User settings' again on this node from configuration wizard.
Answers
Hi,
two general reasons for problems in adding nodes are:
- Windows Firewall settings
- Time Sync
Check both and try.
Hope this will resolve the issue.
Best Regards,
Deepak Bansal
two general reasons for problems in adding nodes are:
- Windows Firewall settings
- Time Sync
Check both and try.
Hope this will resolve the issue.
Best Regards,
Deepak Bansal
Open Configuration Wizard\System Software User Settings
verify all input is correct.
verify all input is correct.
by ATP
Did you try from System configuration console?
by subramani.venkatesh Rank: 1296 on 4/29/2019 11:46:21 PM | Like (0) | Report
System configuration Console of ASDS1, BY the by this is 5.1 Rev A FP1 system.
Add new comment