Hardware lock S1 for ACS200
Hi every body.
I have ACS 200 drive. I want to change parameters. but when I press " * key ", appear "Hardware lock S1 " message in monitor
I adjust S1 Dip Switch in default mode. but appear "Hardware lock S1 " message in monitor again. what should I do to access parameters?
Answers
Hi
I think you refer in your question to ABB model ACS255.
You can find the User Manual at the follow link:
https://search-ext.abb.com/library/Do...
Section 7 of the manual can give the information to set or, if is necessary, reset to factory default parameters.
If the drive is not ACS255 series, could you better explain the type - model?
BR
Flavio
I think you refer in your question to ABB model ACS255.
You can find the User Manual at the follow link:
https://search-ext.abb.com/library/Do...
Section 7 of the manual can give the information to set or, if is necessary, reset to factory default parameters.
If the drive is not ACS255 series, could you better explain the type - model?
BR
Flavio
Hi
you can find attached the operating manual of ACS200 drive.
Try to modify the parameter 225, to unlock the parameters.
Hope this help you
BR
Flavio
you can find attached the operating manual of ACS200 drive.
Try to modify the parameter 225, to unlock the parameters.
Hope this help you
BR
Flavio
Add new comment