Panel pp845a restore
Hi!
I will restore the firmware to factory values in order to solve the slow problem, the only thing that frightens me is that note in hardware manual in 0010.
I suppose it is not my case cause I have a v4.0 version in factory value into the panel and v4.0 in panel builder/project.
thanks!
I will restore the firmware to factory values in order to solve the slow problem, the only thing that frightens me is that note in hardware manual in 0010.
I suppose it is not my case cause I have a v4.0 version in factory value into the panel and v4.0 in panel builder/project.
thanks!
Asked 10 months ago
Voted best answer
1
Dear friend,
You can try factory restore with dip switches, but I don't think it will solve the problem with slow operation of the panel.
I faced the similar problem with slow operation of PP845 and it still exists, even after factory restore of the panel.
May be somebody else could share his experience here.
I guess the problem started when the project's size came close to the memory limit of the panel (too much trends for example).
I found one temporary solution - download the proect with checked "Force file delete in the terminal":
![]()
You can try factory restore with dip switches, but I don't think it will solve the problem with slow operation of the panel.
I faced the similar problem with slow operation of PP845 and it still exists, even after factory restore of the panel.
May be somebody else could share his experience here.
I guess the problem started when the project's size came close to the memory limit of the panel (too much trends for example).
I found one temporary solution - download the proect with checked "Force file delete in the terminal":
Answers
1
Hi,
if you have same version in factory value & in your Panel Builder project, then it should be fine to load the project right after factory reset (OBS remember to note down the settings before you do the factory reset).
If the versions are not the same, no problem again, after reset to factory setting, you only need to also upgrade the firmware to the newest version again (recommended due to bug fixes, etc). Then you can upload your panel builder project (check compatibility).
BR
if you have same version in factory value & in your Panel Builder project, then it should be fine to load the project right after factory reset (OBS remember to note down the settings before you do the factory reset).
If the versions are not the same, no problem again, after reset to factory setting, you only need to also upgrade the firmware to the newest version again (recommended due to bug fixes, etc). Then you can upload your panel builder project (check compatibility).
BR
Answered 10 months ago
Add new comment