IPConfig Detects the PM866 System Reset and Waits for Startup but I am getting the "Connection to Controller Lost"
My PM866K01 is working perfectly When I connect it through Control Builder. But I am not able to connect it to IPConfig tool. I have checked the Serial Cable which is OK. Connecting the controller to PC/Laptop as per the Documented Instructions. It detects the system reset and waits for the controller to start up but a message appears "Connection to controller lost. Please reconnect the Controller". I need to Connect the controller using this tool! I know the IP could be changed through Control Builder. But this Controller should Connect through IPConfig. And yes I have been through the forum with similar problems. I have connected all the necessary Terminators. Used PuTTy and HyperTerminal. No errors were detected except the "System Time Quality: BAD" I don't know whether it matters or not.
Thanks in Advance.
Design and Application Engineer