Failed to Access configuration in AC 800F using hyperterminal?
the controller start to boots, and I pressed the “space” button to access the configuration, to setup the IP address.
but the controller goes directly to run mode, and I cannot access the configuration, I tried many times pressing space but couldn't
is there any special configuration I have to made? Or there is any other method to set the IP for more than 14 controller
Set controller in STOP mode from RUN/STOP button on hardware.
And then power off/on controller, after some text seen in hyper terminal keep pressing space button you will landup in configuration mode. Press <c> and you will get option to change several things and IP address is one of it.
Hope it helps you.
Are you sure your cable is well? You can test this by swapping both ends of the cable. If you also see bootmessages after this, the cable is good.
Have you select the right com port?
Have you select the right port parameters? (Bits per second:9600, Data bits:8, Parity:none, Stopbits:1, Protocol: none)
Have you opened the connection by clicking "call"-->"connect" in hyperterminal?
Are you sure the cable is right? This has to be a cable with crossed RxD and TxD (this is called a nullmodem cable). See https://www.galaxisboard.com/faq/imag...
Finally to change the IP address from software, the Address-Switch on the Network card have to be "0".