Analog Output configuration
Hello
I am trying to configure an analog output in the DCS Freelance using AO890 remote I/O, to control manually this output I am using a Set Point Controller C_ANA connected to an analog output transformation, AO_TR and this block to the analog output (4-20 mA), but when I connect the AO_TR to the AO the line turns red and the loop doesn't works. I would like ton know if this configuration is OK?
Thanks for your help.
Orlando
I am trying to configure an analog output in the DCS Freelance using AO890 remote I/O, to control manually this output I am using a Set Point Controller C_ANA connected to an analog output transformation, AO_TR and this block to the analog output (4-20 mA), but when I connect the AO_TR to the AO the line turns red and the loop doesn't works. I would like ton know if this configuration is OK?
Thanks for your help.
Orlando
Voted best answer
Dear Orlando,
The Data Type output of the Analog Output Transformation Block is Real, you need to use data type conversion.
Thanks
The Data Type output of the Analog Output Transformation Block is Real, you need to use data type conversion.
Thanks
Add new comment