Unable to change alarm setpoints from standard library faceplate and control builder
Dear all,
I am unable to enter new alarm set point values from faceplate or via control builder.
Each time I enter a new value within range,the value reverts back to the existing value. I am able to change the values of other parameters such as AEfilter time.
The 800xa user has Tune permission.
What could be the reason and a possible solution.
Regards
Rahil
I am unable to enter new alarm set point values from faceplate or via control builder.
Each time I enter a new value within range,the value reverts back to the existing value. I am able to change the values of other parameters such as AEfilter time.
The 800xa user has Tune permission.
What could be the reason and a possible solution.
Regards
Rahil
Voted best answer
Hi,
check if existing alarm value (parameter) is written forcefully in structure text in control builder. Is this 800M ?
check if existing alarm value (parameter) is written forcefully in structure text in control builder. Is this 800M ?
by rahilmohammed Rank: 59 on 2/5/2019 12:24:46 AM | Like (0) | Report
FB is SignalInReal
Add new comment