Batch Management 6.0.3.2 Error: Could not connect to SymflexMirroringOperations database ?
Hi,
After deploying Primary/secondary Batch Management Servers and I have chosen a Witness Machine as an secondary aspect server during installation of sv6.0.3.2,
I began doing the post-install as mentioned in the Documentation by launching the ABB Batch Mirroring Utility and I Had this error
Why ? Could you help me what is wrong in may installation ?
![]()
Thanks for help.
Best Regards
After deploying Primary/secondary Batch Management Servers and I have chosen a Witness Machine as an secondary aspect server during installation of sv6.0.3.2,
I began doing the post-install as mentioned in the Documentation by launching the ABB Batch Mirroring Utility and I Had this error
Why ? Could you help me what is wrong in may installation ?
Thanks for help.
Best Regards
Asked 6 months ago
Answers
0
Hi,
I found what is wrong....
I have applied ABB GPO before sw install release _N_ (Default security policies for System 800xA)... I think one of GPO will be blocked to access.
Now, I disable all ABB GPO and I successful access to access to batch post-install but I have this error:
![]()
What is wrong ?
In secondary Bath, I used MSQL studio to see what is the Symflex database status, it said (restoring...)
So what action could I do to do successfully bath post-install ?
Thanks for your help.
I found what is wrong....
I have applied ABB GPO before sw install release _N_ (Default security policies for System 800xA)... I think one of GPO will be blocked to access.
Now, I disable all ABB GPO and I successful access to access to batch post-install but I have this error:
What is wrong ?
In secondary Bath, I used MSQL studio to see what is the Symflex database status, it said (restoring...)
So what action could I do to do successfully bath post-install ?
Thanks for your help.
Answered 6 months ago
Add new comment