Уважаемый Колё Стоилов! При включенииПЧACS800 на панели управления появляется ошибкаNoCommunication(8)Что делать?
Нужна Ваша помощь!
you should kindly write in English, to give us a way to understand what your question is.
Not everyone knows the Cyrillic ....
Probably you have one problem in RMIO control board, to have a confirm about this you can test with a different control panel or better with a Drive Window SW connected to your PC.
Hope this help you
From the FW manual:
Warning: NO COMMUNICATION (X)
Cause: Cabling problem or a hardware malfunction on the Panel Link.
What to do: Check Panel Link connections.Press RESET key. The panel reset may take up to half a minute, please wait.
Try to remove the control panel. Check the connector between the panel holder (ADPI) and the panel (Ethernet connector).
Also check the cable connection (Ethernet cable) between panel holder and the drive board RMIO (it depends on your ACS800 size)
There should be Red and Green LEDs on ADPI,- what is their status?
Source: ACS800 Firmware Manual