ppotype 4 does not update with refresh
Good afternoon I have a problem with an acs800 drive, I'm trying to communicate via profibus dp with dcs 800 xa I have added all the software, when I'm configuring the drive I want to change the ppotype from the default 1 to the 4 but when I do the reset returns to value 1, I do not know what to do, this drive is in a new area I do not have wiring yet the control part of the discrete signals that is, I do not have any discrete signal connected, I do not know if any bridge is important, make the bridge between 11 and 3 of the terminals, there is also the one that comes by defaul between 8 and 11. It is the only parameter with the I have problems others if they update and is the last to be able to put the drive online and test. I wait for your help.
Only for the acs800 drive:
when you have selected the fieldbus at parameter 98.02 and at parameter 51.01 the ProfiBus, the PPO will go to indicate to parameter 51.04. Once you have done this you must remember to refresh the parameter 51.27.
As for the DCS, I'm sorry, 800XA is not my cup of tea...
Hope this help you