redundant controller PM866
Hi, can someone please share the procedure to make the controller redundant.?
I have tried but its not working. may be I am missing out some step.
I have tried but its not working. may be I am missing out some step.
Answers
In CB go to PM86x hardware, press right button in redundancy Add Redundant Unit.
Run config IP , connect to Primary controller, go to Settings / Set Backup IP Address. I use - Obtain IP address by using default rule.
Please check that redundancy cables are connected correctly, cable end with text upper connected to Primary controller.
Run config IP , connect to Primary controller, go to Settings / Set Backup IP Address. I use - Obtain IP address by using default rule.
Please check that redundancy cables are connected correctly, cable end with text upper connected to Primary controller.
If you use modulebus comunication, please care about the optic fibre.
If the connection is not very good the redundancy of the PM fails.
If the connection is not very good the redundancy of the PM fails.
Add new comment