zint board
Hello
I have a board( zint -592 without rating).
By installing this board on the drive(acs580-01-430a-4), we encounter an id rating missmatch fault.
What should we do to fix this?
in acs800 drives we configured by soldering in rint boards.but i don't know configuring zint boards.
I have a board( zint -592 without rating).
By installing this board on the drive(acs580-01-430a-4), we encounter an id rating missmatch fault.
What should we do to fix this?
in acs800 drives we configured by soldering in rint boards.but i don't know configuring zint boards.
Voted best answer
Hi
AFAIK, ZINT 592 is used in ACS880 series. In fact, you have one slot to insert the memory unit. ACS580 do not have memory unit.
Who advised you to use this type of card on ACS580?
In any case, a new card requires the pre programmed SW from the factory, or that an Authorized ABB Service and with the appropriate skills and tools, can possibly load on a new board, an appropriate FW.
AFAIK, ZINT 592 is used in ACS880 series. In fact, you have one slot to insert the memory unit. ACS580 do not have memory unit.
Who advised you to use this type of card on ACS580?
In any case, a new card requires the pre programmed SW from the factory, or that an Authorized ABB Service and with the appropriate skills and tools, can possibly load on a new board, an appropriate FW.
Answers
There is a board on the drive. And in the abb documents it is also referred to.
Add new comment