Dual startup sync ended with Errors DIC
Front end xa4.1
Back end Safeguard AC415
We are facing an issue of DIC mismatch sync error.
Following is the message in MMCX
"Dual startup sync ended with Errors DIC"
Checked both side database for any DIC mismatch. Corrected DIC mismatch.
Rebooted Both side controllers one by one.(cleared and rebooted Side A controller and loaded backup of Side A in SideB controller)
Rebooted both controllers simultaneously.
Still the same message "Dual startup sync ended with Errors DIC" in MMCX.
Anybody has faced this issue ?
Answer this question Follow
How did you correct DIC mismatch ? By deleting or creating more DIC's ?
By deleting be careful not to get 'holes' and DDB is not enough normally, you shall use syst level *FINS 8,xxx DINS in P2 mode
Even the MMCX says DIC you should verify all LF 8 (DI signals)
Other questions needing answers
Safety Systems >
Application Knowledge Store (AKS) will no longer be available after the 31 July 2021.
We are enhancing our Customer and Partner experience and will be migrating data from AKS to the new portal.
During the transition please direct your questions to:
If you are an ABB customer with a CARE Agreement you can access our Customer Portal, where you can find solutions and ask questions, and communicate directly with ABB.
If you are not an existing CARE customer with ABB please contact your local ABB sales office.
For our authorised Partners you can directly access additional support information in the Partner Portal