how to reset factory defaults settings for pm564

Hi all,

I am working with a PM564 CPU and The Lan led will not turn on

I think.... need to restore it, to factory defaults settings. Please anyone know how to do this...help me

Regards,

Meysam

Comments (0) New comment

meysam.noorelahi Rank: 1460

Asked 11 months ago

Answer this question Follow

Answers

You can refer to this post:

https://forum-controlsystems.abb.com/...

Comments (1) New comment

prksh Rank: 132

Answered 11 months ago

Hi

you can find one good trace of the restore operation in my old post at the follow link:

https://forum-controlsystems.abb.com/...

Hope this help you, let us know about the results

Comments (5) New comment

by meysam.noorelahi Rank: 1460 on 10/24/2018 3:56:47 AM | Like (0) | Report

thank you
I saw that post...
But my cpu( pm 564-rp-Eth) does not have a screen or button...
only run- stop...

by Flavio Mussolin AKS expert

Rank: 4 on 10/24/2018 5:30:49 AM | Like (0) | Report

Hi
extract from my old post, 2nd part:
"AC500-eCo CPU:

Turn off the CPU, place the frontal white lever to STOP, turn on the CPU.

In this way are set automatically the default parameters in the PLC (as above), and to be able to connect to the CPU in online mode, set as above, from Codesys, in "comunication parameter" default parameters (19200 - 8N1)"
Now you can made one new scan of the IP adress of the cpu, or if you use TK 503 cable, you can set the parameter data for the communication.

try this procedure and lets us the results

by meysam.noorelahi Rank: 1460 on 10/25/2018 9:00:52 AM | Like (0) | Report

I can not connect to the Cpu... Because when I plug the cable LAN ...the Lan led does not turn on ...
And I don't have tk503 cable...
what do I do...! ؟! ؟

by Flavio Mussolin AKS expert

Rank: 4 on 10/26/2018 12:05:22 AM | Like (0) | Report

Hi
with your version of Automation Builder - with the RJ 45 cable connected - one final test is to try to do from menu --> tools --> IP configuration -- "SCAN" and verify if Automation Builder can find the cpu. If the program could not find the cpu, you need to consider one probable damage of the unit.
If the the program could find the cpu, you can try to modify the IP adress and try to go online with the cpu. The next action is to reset at original status the cpu.
You did not tell us if you have the program inside the cpu, which I think is not new but used. Be careful because the reset of the cpu deletes everything inside and if you do not have the original sw - that is what was originally compiled in the cpu - doing so will delete the whole