about configuration I/O at the AC 800M
Answers
few checks worth to carry out
1. make sure backplane communication is established by properly plugging in the module.
2.check if you have the right firmware
3. Properly terminated.
1. make sure backplane communication is established by properly plugging in the module.
2.check if you have the right firmware
3. Properly terminated.
- Did you configure the correct address to the IO module (address 1, not 101 for example)
- Did you also connect your power supply to the IO module? I cannot see it clearly on your photo but it needs power to work properly.
Add new comment