Problem in MB300 Alarm & Event List
After CPU power restart, Alarm & Event list for a particular MB300 node is not working in the MB300 network.
Other Nodes Alarm & Event list are working without any problem.
The same problem was noticed earlier. And, found that RTA node was missing in the Master Table View.
So, manually added the RTA node in the particular CPU and Alarm & Event list is started to work.
This time also found the RTA node was missing in the Master Table view, manually added the RTA node.
but, Alarm & Event list is not working.
I would like to get clarification for,
1. Why the RTA node gets disconnected from the CPU during power restart ?
2. Can we try by removing & Adding back the RTA node which might solve the problem ?
System details :
CPU type - AC 450, PM510
CPU total - 4 nos (2 CPU in each Rack)
attached the screen shot for more details.
appreciate your quick reply.
Answer this question Follow
First of all check your node descriptors on the RTA board(s)... There might be a node descriptor towards this node, that blocks events (property EVENT = 1) from that particular node...
Other questions needing answers
Alarm & events >
Legacy DCS >
Advant Master >
Application Knowledge Store (AKS) will no longer be available after the 31 July 2021.
We are enhancing our Customer and Partner experience and will be migrating data from AKS to the new portal.
During the transition please direct your questions to:
If you are an ABB customer with a CARE Agreement you can access our Customer Portal, where you can find solutions and ask questions, and communicate directly with ABB.
If you are not an existing CARE customer with ABB please contact your local ABB sales office.
For our authorised Partners you can directly access additional support information in the Partner Portal