AC500-eCO PM 566
Hello,
I am pretty new to PLC programming and what I did was use Automation builder to create a project for AC500 ECO PM566 plc and wrote a simple program in codesys. The program runs fine in the simulation mode and I have a couple of doubts going ahead from there.
- When I run the simulation in Codesys I see couple of DIs true and couple of DOs true but the same is not reflected in OBIO when I check in Automation builder, is this usual?
- Am I supposed to copy this program to the SD card and load it in the PLC to change my Onboard I/O or the program is already in my plc's CPU.
Apologies if the questions are dumb.
Any help is appreciated.
I am pretty new to PLC programming and what I did was use Automation builder to create a project for AC500 ECO PM566 plc and wrote a simple program in codesys. The program runs fine in the simulation mode and I have a couple of doubts going ahead from there.
- When I run the simulation in Codesys I see couple of DIs true and couple of DOs true but the same is not reflected in OBIO when I check in Automation builder, is this usual?
- Am I supposed to copy this program to the SD card and load it in the PLC to change my Onboard I/O or the program is already in my plc's CPU.
Apologies if the questions are dumb.
Any help is appreciated.
Answers
Hi,
There is basic configuration of Communication profile parameters of PLC and IP configuration of your PLC . Then you can download / Run your program into PLC.
Below link for your reference.
https://www.youtube.com/watch?v=L0HhK...
Thanks
There is basic configuration of Communication profile parameters of PLC and IP configuration of your PLC . Then you can download / Run your program into PLC.
Below link for your reference.
https://www.youtube.com/watch?v=L0HhK...
Thanks
Add new comment