system configuration console does not show 'config system'
I am creating new 6032 system based on 6031 system backup. I have followed the procedure from 2PAA111708-600 N 'Move a system' chapter. But after a lot of effort i cannot see 'COnfig system' in system configuration console. Is there any solution to fix this. (Other than upgrading the 6031 to 6032 and take a new system backup or vice versa)
Voted best answer
There are two reasons I know when this happens. Not all services in running state (you will have this on a test system where you don't have opc connection to a controller). The second reason if the maintenance loading of an extension has failed. You can the go to the configuration wizzard and got to 'system extension maintenance' to load the failed extension. then you should be able to go into the wizzard again.