ABB REL 511

We have ABB REL 511 with firmware version 2.0 and there is a problem in connecting to this protection relay. In other words, we can just send configuration to this relay but we can not get config from this relay by using CAP 540 SP5. Is there any way to solve this problem? Can we update relay firmware to solve this problem? If there answer is yes, how can we do this?

With best regards

Comments (8) New comment

by Stefan Stromqvist AKS expert

Rank: 1 on 7/9/2018 7:15:58 AM | Like (0) | Report

Not my area of expertise. Sorry.

by hasankarimi6464 Rank: 389 on 7/9/2018 8:24:18 AM | Like (0) | Report

thank you very much.would you please tell me who i can ask this question from?

by Stefan Stromqvist AKS expert

Rank: 1 on 7/9/2018 8:46:49 AM | Like (0) | Report

Sorry, no idea - I specialize in ABB automation, not power products.

We must cross our fingers that someone else here on the AKS forum can answer.

by hasankarimi6464 Rank: 389 on 7/9/2018 8:48:42 AM | Like (0) | Report

thank you very much.

by hasankarimi6464 Rank: 389 on 7/9/2018 8:51:16 AM | Like (0) | Report

thank you very much. i live in IRAN and we have no representative to ask this question. would you please do me a favor and ask this question from ABB Contact service in USA?

by Stefan Stromqvist AKS expert

Rank: 1 on 7/9/2018 10:23:03 AM | Like (0) | Report

I cannot promise anything, but I will try to reach someone that might know.

by hasankarimi6464 Rank: 389 on 7/9/2018 10:14:54 PM | Like (0) | Report

thanks again. i do appreciate your help

by Stefan Stromqvist AKS expert

Rank: 1 on 7/13/2018 7:39:35 AM | Like (0) | Report

I got this URL from a contact:

https://new.abb.com/substation-automation/products/protection-control/relion-product-family

Add new comment