AC800M - MotorUni motor block
Im using the MotorUni block in my program. I need some clarity on the connections made to the block.
Please check if my assumptions are correct:
- If i connect a signal to the "SetAuto" the motor is in auto mode??
- Now to start the motor in auto, "AutoCMD1" must be 1??
- To stop the motor, "AutoCMD0" must be = 1 and "AutoCMD1" = 0??
Now my next question is, how do i start the motor in manual??
Which inputs do i use to start & stop the motor??
Also, which input do i use for "Local" mode, and do i need to use the same inputs (Start & Stop) as manual??
Voted best answer
Your assumptions are correct. Please note that AutoCMD1 is not considered when AutoCMD0 is true.
Manual mode can be selected from faceplate when SetAuto is false. Then the device can be operated from faceplate, not from parameter inputs.
In Local mode, feedback monitoring is disabled and the device shall be operated only from field/MCC panals. So only LocMode input need to be connected for local mode operation.