How to configure Actual Values And Ref. ACS800 and ACS850
I control the driver on 800xA via profibus. I can read SW and Actual Speed and also I can send speed set point. In PPO Type 4 Connections there are 6 In 6 Out( Status, Speed Act, Actual 3, Actual 4, Actual 5, Actual 6. I think its possible to take current valuei power etc in Act3 or others. How can i configure Actuel 3 is Current value?
(In ACS800 I set PZD3=104 or122 but values are 0 )
Voted best answer
Which parameter have you set? PZD3 In or PZD3Out?
If you want to get Actual Current from ACT3(Control Builder M side), you have to set PZD3 IN (parameter51.06) as 104.
If there is no motor connected to the driver, you cant monitor output current according to your mode(scaler or DTC). Please check this parameter also.