ACS800 AMXR7260 AP programming problem
I am trying to implement one logic in ACS800 (ACS800-04-0005-3) AMXR7260. below 5Hz when I will start a drive with motor then it gives a motor phase loss fault. And above that frequency it operates normally. Now in Adaptive programming I am implementing a logic where below 5Hz the motor phase loss in 30.19 will be in deactive mode and above 5Hz 30.19 parameter will be active the fault. Now I have used a compare block. But it is not working as per description. All the time it holds a value 4. I have attached a Pdf file. If you have any solution of the problem please give information.
This question has not yet been answered.