For PM 564-ETH, i am getting an error,message "error timeout DHCP(>30s) fallback IP. error code OAFF0859
For PM-564-ETH,with AX561 and DX561 modules."error timeout DHCP(>30s) fallback IP set by configurator,check network IP adress,wiring)Check DHCP server."I have acknowledge the error and proceeded with downloading the prg in PLC but when i run the prg i am unable to come in run mode and create boot project if i restart PLC there is no program on PLC.also i have error led ON for AX561.i am using control builer ver 2.4 and PLC firmware is 2.3
and codesys 184.108.40.206
Voted best answer
first you do not have any error in AX561, this error (led) may be depend on incorrect parameter for this unit in Control Buider or fault wiring.
Next, if the configuration are right in control builder, you can test the dowload in the cpu, without program. With this operation you can test the state and the operation of cpu.
Compile the empty program in Codesys and download in the cpu, the communication parameters would be set previously.
When the cpu come in run state, the configuration hardware are OK!
Next, write the program in codesys and compile without error..after download, the cpu must be in run mode....
Hope this help you, let us know about the results.