Can't load the station to emulator !
Dear all, i am new with ABB control systems and i have some questions about Freelance 800F ,firstly i have installed Demo version of freelance v9.2 and i'm starting to make small project like the one in the Tutorial and after completing configuration and try to load the station to the Emulator it gives me a message that "the block is incorrect " So how do i make it right ??
more information :-
i have configure the freelance with IP : 192.168.1.122
255.255.255.0 (attach 1)
and network configuration like (attach 2)
by the way may wirless card has ip :192.168.1.122
Voted best answer
I recommend you to go through getting started manual under user doc and some videos on demo dvd which will get you started with freelance. demo dvd contains good amount of informations apart from executable. I am sure you must have loaded emulator till this time. you can run your emulator on local host address, too. i.e on 127.0.0.1:8888.
-Remember to make the resource allocation on the HW Configuration.
-Start the MS Internet Explorer en write 192.168.1.122:8888/index.html (Check configuration of explorer so no proxy is configured), then set Station to "1" in your example and start the controler.
-"Check" the program that you are trying to download.
- Go no Commitioning mode
- And load Whol estation.
Note: If you don't want to have problems with time sincronization Your network mask must be 255.255.240.0.