CP 607 image flicker for a minute
I have set up a ABB CP 607 and experience some flicker after screensaver disables for about a minute, and then everything is working fine.
Has anyone experienced this? Could it be relatet to that the screen needs to be warm. It is 22 deg C where I have set it up now, but I am planning to use this in way colder enviroments and are a bit concerned with this.
Are there any settings that I can adjust maybe?
I have used a few CP620 with screen server and didn't find such a flickering after screensaver off. For the screen saver I'm using some simple moving letters, not just a blank screen.
In the tech spec of CP607 is written operating temp 0-50oC, and some comments about higher than 24oC, so your ambient temperature should be OK.
In system settings of the panel (not trough Panel Builder, but during startup at power supply on) there is Display folder, you could check there. May be to check automatic backlight turnoff or to decrease a little bit brightness?