Is there a setup to Close All Overlaps when changing Base Display
does anyone know if there is any switch in 800xA Workplace to force the closing of all Overlaps when changing the Base Display.
The operators are complainig about faceplates and overlaps tied to a base display reamining on the screen even if the base display was changed.
They do not like using the Close All Overlap Button.
I am thinking about using a PG2 Input Item "Verb Invoker" to do that, but if there is an easier way I would prefer that.
The problem could be that the "Close All Overlaps" will also close "pinned" faceplates and displays. So the operators would not be able to pin a faceplate and then change displays. This could be quite a serious problem if they want to monitor two objects that are not in the same display, hold trend displays open etc.
I think its possible that "the cure will be worse than the disease"